

Step 1
REMOVAL OF ELECTROMAGNET
Cut the wire from the terminals on electromagnets with nippers.
It is recommended that you make a note of the wiring

Step 2
Undo the frame screws and remove the SP switch

Step 3
Remove the nuts with the box driver. (8mm wrench)
Pull out the electromagnets from the pump body.

Step 4
FITTING THE ELECTROMAGNET
Secure the electromagnets to the body by the nuts.
Use the box driver. (wrench)

Step 5
Secure the SP switch to the frame by the screws.
• Be careful of the direction.

Step 6
Tie the wire in a bundle with a silicon tube. Strip off the coating each of the wire. (7mm from the end) Connect the wire to the terminals. Solder the wires to the terminals. The wire requires a soldered connection.

Step 7
This completes the electromagnet replacement procedure.